If the needle hits the bobbin case, it may break the tip of the needle. This usually happens if the bobbin case is not placed correctly. After cleaning your sewing machine, you may fail to put back the bobbin case into its original alignment. … This means that your sewing machine is not synchronized.
How do you stop a needle from hitting a bobbin case?
- If your needle is hitting the bobbin case in your machine stop your machine and follow the steps below. …
- Turn your machine off.
- Raise the needle to the top position.
- Slide the needle plate cover release to the front of the machine and remove the needle plate cover.
- (1) Needle plate cover (2) Needle Plate cover release.
How do I know if my timing is off on my sewing machine?
Timing usually goes out in your sewing machine after the Needle and thread gets jammed. You can tell you sewing machine is out of time when you can no longer sew as the hook timing is out and the bobbin thread isn’t getting picked up. Or when your sewing stitch is starting to look horrible.
When should I replace my bobbin case?
As long as you take good care of your bobbin case, it will perform well. However, eventually, it will cease to sew smoothly and will need to be replaced. Sometimes people think they only need to replace certain parts of the bobbin case, like the tension spring or the tension screw.
What causes sewing machine timing problems?
The hooks are the most common issue concerning sewing machine’s timing. The second most common issue is related to the needle. The first step is to check the sewing machine’s timing to make sure that there is a problem. … If the hook is turning clockwise, the needle must be moved to the far right.
Why is my needle not in the center?
Watch the needle in relation to the needle plate hole as the needle descends into the hole. As the needle travels down, if the needle drifts closer to one side of the hole and then backs off again as you withdraw the needle you’ve got yourself a bent needle. If so, replace the needle. If this ain’t the case, read on.
Why does my needle keep hitting the presser foot?
There are several reasons why the needle keeps hitting the presser foot/needle plate: 1. The presser foot you are using may not be appropriate for the type of stitch that you want to sew. … Check that the needle is not bent, if so replace the needle.
How much does it cost to fix the timing on a sewing machine?
To save yourself some money on buying the service manual you can take your machine to a qualified repairman and he should be able to repair the timing for about $50 to $80. That fee probably will change depending on where you live and the type of machine you need to have repaired.
How do you fix a bobbin problem?
How to Fix Bobbin Thread Bunching and Other Threading Problems
- Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
- Change the Needle. …
- Inspect the Bobbin. …
- Clean the Machine.
What am I doing wrong with my bobbin?
My Bobbin Moves Slowly Or Gets Stuck
It’s very common to have problems sewing caused by the bobbin case not moving freely or getting stuck, causing jamming or skipped stitches. … It can also occur if the bobbin thread is not attached correctly, the thread has formed a knot or a problem with the bobbin case.