The bobbin keeps pulling and jamming collecting a lot of thread beneath your fabric. There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. … This will cause tangling underneath the fabric.
How do I fix bobbin thread bunching up?
How to Fix Bobbin Thread Bunching and Other Threading Problems
- Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
- Change the Needle. …
- Inspect the Bobbin. …
- Clean the Machine.
Why is my thread bunching underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
What tension should my sewing machine be on?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
Why does my thread keep jamming?
The tension could be too tight or too loose. Set the tension to the basic thread tension setting or adjust the tension manually. The combination of the needle size, thread size and fabric is incorrect. Be sure to use the correct size needle and thread for the type of fabric that you are sewing.
Why is my bobbin thread not catching?
If it is not in the correct position, the needle will not go down and pick-up your bobbin thread. … Also, make sure your bobbin is in correctly (not backwards) and that the upper tension disks of your machine are threaded correctly. Make sure the presser foot is up when seating the thread through the upper tension.
How do you tighten thread tension?
Turning the screw a tiny bit counterclockwise will loosen the bobbin tension; turning it clockwise will tighten the tension. Some quilters keep two bobbin cases on hand, leaving one as-is from the factory and using the other when they need to make adjustments.