The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.
Why is my thread bunching underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
What should tension be set on sewing machine?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
How do I stop my sewing machine from bunching?
How to Fix Bobbin Thread Bunching and Other Threading Problems
- Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
- Change the Needle. …
- Inspect the Bobbin. …
- Clean the Machine.
When should I adjust the tension on my sewing machine?
When lower tension is too loose (or upper tension is too tight), knot is visible on right side (left). When upper tension is too loose (or lower tension is too tight), knot is visible on wrong side (right). Tensions can still need adjustment even if they’re balanced.
How do you fix sewing tension?
No matter what the problem, start by adjusting the top (needle) tension:
- If you’ve determined that more tension (strength) is required for the needle thread, turn the tension knob (or digital setting) up just a bit (refer to your manual).
- If the bobbin needs a little more pull, lower the needle thread’s tension setting.
How do you adjust thick fabric tension?
The thicker the fabric, higher the tension must be to lift the lower thread up to the middle of the layers of fabric. You will usually be alright with a 4 or 5 on medium to medium-heavy fabrics like linen and twill weaves such as drill and denim.