Place a small screwdriver on the head of the screw on the side of the bobbin case. Turn very slightly clockwise to increase the tension on the Singer bobbin. Turn slightly counterclockwise to decrease the bobbin tension.
How do I reset the bobbin tension?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
Why is my Singer sewing machine bunching thread on the bottom?
Threads can get bunched up at the beginning of sewing if the top and bobbin threads have not been properly placed underneath the presser foot before starting to sew. Ensure that both threads are under the presser foot and placed toward the back of the machine before lowering the presser foot to start sewing.
Why is my thread looping underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
What is the normal tension setting on a Singer sewing machine?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics.
Why is my bobbin thread bunching up?
There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. The bobbin could also be placed incorrectly. More than likely, you forgot to put the bobbin back correctly while cleaning your machine.
How do I fix bobbin thread bunching up?
How to Fix Bobbin Thread Bunching and Other Threading Problems
- Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
- Change the Needle. …
- Inspect the Bobbin. …
- Clean the Machine.
How do you tighten thread tension?
Turning the screw a tiny bit counterclockwise will loosen the bobbin tension; turning it clockwise will tighten the tension. Some quilters keep two bobbin cases on hand, leaving one as-is from the factory and using the other when they need to make adjustments.
What width should my sewing machine be on?
A straight stitch has no width so it makes sense to set the dial at “0”. However, each machine varies so you will want to set the Stitch Width dial at the position where the needle is centered over the stitch plate. This will give you the most accurate seam allowance.