Frequent question: When should I adjust the bobbin tension?

If the tension isn’t perfect, fix it by adjusting the bobbin spring; tighter if the bobbin thread shows on the upper layer, and looser if the needle thread shows on the underlayer. Make another test seam, and examine the stitches, repeating until the stitch is balanced.

Why is my bobbin tension so loose?

Needles, threads, and fabrics: Different thread sizes and types on top and in the bobbin can throw off basic tension settings. A needle that’s too large or small for the thread can also unbalance your stitches, because the size of the hole adds to or reduces the total top tension.

What number should the tension be on a sewing machine?

As the bobbin thread tension is factory-set and wouldn’t usually be adjusted for normal sewing. So we’ll be talking only about the top thread tension since that’s where you’d usually make the adjustments. The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing.

What should bobbin tension be?

Proper bobbin tension is essential to good embroidery. If tension is too tight, unwanted bobbin thread may begin to show on top of your garment and you may begin to experience frequent thread breaks which wastes time and money. Bobbin tensions should be 18 to 22 grams (up to 25 grams when embroidering caps).

IT IS INTERESTING:  What are the most important features of a sewing machine?

Why is my bottom stitch looping?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

How do I know if my bobbin tension is too loose?

The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.

What width should my sewing machine be on?

A straight stitch has no width so it makes sense to set the dial at “0”. However, each machine varies so you will want to set the Stitch Width dial at the position where the needle is centered over the stitch plate. This will give you the most accurate seam allowance.

Why is my thread bunching up?

As “thread bunching” occurs on the underside of the fabric, some people think it is due to the lower thread. They check whether the bobbin is sitting correctly in the bobbin case or even replace the bobbin. … In addition, the correct ratio of upper and lower sewing thread to the needle is important.

Why does my sewing machine keep jamming underneath?

However certain you are that the problem with the machine is most likely due to a huge tangled mess of thread in the bobbin underneath the fabric, the most common reason for the jamming is usually the lack of sufficient tension in the upper thread.

IT IS INTERESTING:  How do I start my own sewing business?

How do I fix bobbin thread bunching up?

How to Fix Bobbin Thread Bunching and Other Threading Problems

  1. Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
  2. Change the Needle. …
  3. Inspect the Bobbin. …
  4. Clean the Machine.

12.12.2019

Why is my bottom stitch not catching?

If you are experiencing your bottom thread bunching underneath, it is almost certainly a tension issue if your top tension and bottom tension are different. If your thread is looping underneath, then your top tension is too loose compared to the bobbin tension.

Needlewoman