Thread from the spool goes through the needle’s eye. Thread from the bobbin comes up through the needle plate.
How does needle pick up bobbin thread?
You should see a small loop come up through the needle plate (this is your bobbin thread), using the tip of a narrow object like a pencil or scissors, pull the loop up and then pull both threads (top and bobbin) under the foot and toward the back of the machine.
Where does the bobbin thread go?
Once you have a wound bobbin, it goes in the machine’s bobbin case to supply the lower thread as your machine sews. To load your bobbin, lift your needle and presser foot to the highest position (your machine will either use a hand wheel or a button for this) and remove the bobbin cover.
Why does my thread bunch up underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
Why won’t My Brother sewing machine pick up the bobbin thread?
There could be several things that could cause the machine not to pick up the bobbin thread. The upper thread could be tangled. Remove the thread completely from the machine. The correct size spool cap should be used for the size of the thread spool.
Can I sew without a bobbin?
You can’t sew without a bobbin, as the machine requires two spools in order to operate properly. Therefore, you will need to add the bobbin thread in addition to your needle thread.
How does the bobbin thread work?
The bobbin sits just beneath the needle in its compartment,known as a bobbin case. … If you happen to look at a sew being formed, you will see how the needle reaches into the bobbin case and pulls a thread for each cycle, loops it with the upper thread, and creates a complete sew on the pressed fabric.
Does thread go under presser foot?
Double check to make sure the thread is through the tension properly. Once you’ve threaded the needle, put the thread straight back (but not under the presser foot). Keep the presser foot up, and note that the thread should be fairly easy to pull.
What tension should my sewing machine be on?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
How do you fix bobbin tension?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
What is wrong with my bobbin thread?
There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. The bobbin could also be placed incorrectly. More than likely, you forgot to put the bobbin back correctly while cleaning your machine.
Why is my bobbin not moving?
My Bobbin Moves Slowly Or Gets Stuck
This usually happens if there is grease and dust build up in the bobbin compartment. It can also occur if the bobbin thread is not attached correctly, the thread has formed a knot or a problem with the bobbin case.